Installation guide

G-SYNC INSTALLATION GUIDE VER. 2.0 | Page 10 G-SYNC INSTALLATION GUIDE VER. 2.0 | Page 11
06. Disconnect the LVDS cable.
Unplug the LVDS connector by pressing the two locking clips on the edges of the
connector and gently pulling out the connector.
07. Disconnect the power cable.
Unplug the power connector by lifting up the lock at the top and gently pulling
out the connector.
04. Mark the corners of the chassis.
Using the marker, mark where the chassis meets the LCD panel in all four
corners to assist in realigning during reassembly.
Note: It’s very important that the chassis is placed in its
original position to close the back cover.
05. Remove the black tape.
Remove the black tape from the top of the LVDS cable.