® Vintage-PE2 Barebone System Quick Installation Guide
Front panel features N O T E . The photos in this guide are for reference only. For detailed information on your system’s specifications, refer to the user guide. External Internal 5.25-inch bays (drive not included) HDD bay FDD bay (drive not included) Reset button HDD LED Power button USB 2.0 ports Microphone port Headphone port Rear panel features Power socket Voltage selector Power supply module PS/2 keyboard port PS/2 mouse port Parallel port VGA port Chassis fan vent USB 2.0 ports USB 2.
Voltage selector The switching power supply that came with the system has a voltage selector switch below the power socket. Use this switch to select the appropriate voltage according to the voltage supply in your area. If the voltage supply in your area is 100-127 V, set the switch to 115 V. If the voltage supply in your area is 200-240 V, set the switch to 230 V. 115 V/230 V Voltage selector C A U T I O N .
Removing the side plate and front cover 1 2 Screw Remove the two screws on the rear panel. 3 I M P O R T A N T . Repeat steps 1 and 2 to remove the other side plate. 4 Side lock tab Release the side lock tabs. Hinge-like tab Swing the left edge of the front panel outward, then unhook the hinge-like tabs from the holes on the right side of the front panel.
