User Guide

2-3
Chapter 2: Setup
2.3 Detaching the base (for VESA wall mount)
Thedetachablearm/baseofthismonitorisspeciallydesignedforVESA
wallmount.
Todetachthearm/base:
1. Disconnectpowerandsignalcables.Carefullyplacethemonitoron
theEPSfoam,withthescreenfacingdown.
2. Removethestandcover.
3. UsetheL-shapedscrewdrivertoremovethefourscrews.Then
removethestandassembly.
4. Removethefourrubberpads.Thenalignandinstallthewallmount
bracketontherearofthemonitor.
Screw holes for
VESA wall mount
(100 x 100 mm)
• Werecommendthatyoucoverthetablesurfacewithsoftclothtoprevent
damagetothemonitor.
• Holdthebasewhileremovingthescrew.
• TheVESAwallmountkit(100x100mm)ispurchasedseparately.
• UseonlytheULListedWallMountBracketwithminimumweight/load
22.7kg(Screwsize:M4x10mm).