User’s Manual
Table Of Contents
- Safety information
- Chapter 1: Product Introduction
- Chapter 2: Basic Installation
- Chapter 3: BIOS Setup
- 3.1 Knowing BIOS
- 3.2 BIOS setup program
- 3.3 My Favorites
- 3.4 Main menu
- 3.5 Ai Tweaker menu
- 3.6 Advanced menu
- 3.6.1 Platform Misc Configuration
- 3.6.2 CPU Configuration
- 3.6.3 System Agent (SA) Configuration
- 3.6.4 PCH Configuration
- 3.6.5 PCH Storage Configuration
- 3.6.6 PCH-FW Configuration
- 3.6.7 Onboard Devices Configuration
- 3.6.8 APM Configuration
- 3.6.9 USB Configuration
- 3.6.10 Network Stack Configuration
- 3.6.11 NVMe Configuration
- 3.6.12 HDD/SSD SMART Information
- 3.7 Monitor menu
- 3.8 Boot menu
- 3.9 Tool menu
- 3.10 Exit menu
- 3.11 Updating BIOS
- Chapter 4: RAID Support
- Chapter 5: Multi GPU Support
- Appendix
1-16
Chapter 1: Product Introduction
Chapter 1
5. USB 2.0 connectors (10-1 pin USB1112, USB1314; 4-pin Type-A USB9)
The 10-1 pin connector allows you to connect a USB 2.0 module for additional USB
2.0 front or rear panel ports. The 4-pin USB (Universal Serial Bus) Type-A port is
available for connecting USB 2.0 devices. These USB connectors comply with USB 2.0
specification that supports up to 480 Mbps connection speed.
DO NOT connect a 1394 cable to the USB connectors. Doing so will damage the
motherboard!
6. Serial port connector (10-1 pin COM1)
This connector is for a serial (COM) port. Connect the serial port module cable to this
connector, then install the module to a slot opening at the back of the system chassis.