User’s Manual
Table Of Contents
- Safety information
- Chapter 1: Product Introduction
- Chapter 2: Basic Installation
- Chapter 3: BIOS Setup
- 3.1 Knowing BIOS
- 3.2 BIOS setup program
- 3.3 My Favorites
- 3.4 Main menu
- 3.5 Ai Tweaker menu
- 3.6 Advanced menu
- 3.6.1 Platform Misc Configuration
- 3.6.2 CPU Configuration
- 3.6.3 System Agent (SA) Configuration
- 3.6.4 PCH Configuration
- 3.6.5 PCH Storage Configuration
- 3.6.6 PCH-FW Configuration
- 3.6.7 Onboard Devices Configuration
- 3.6.8 APM Configuration
- 3.6.9 USB Configuration
- 3.6.10 Network Stack Configuration
- 3.6.11 NVMe Configuration
- 3.6.12 HDD/SSD SMART Information
- 3.7 Monitor menu
- 3.8 Boot menu
- 3.9 Tool menu
- 3.10 Exit menu
- 3.11 Updating BIOS
- Chapter 4: RAID Support
- Chapter 5: Multi GPU Support
- Appendix
ASUS WS C246 PRO
5-3
Chapter 5
5. Connect two independent auxiliary
power sources from the power supply
to the two graphics cards separately.
6. Connect a VGA or a DVI cable to the
graphics card.
5.1.4 Installing three CrossFireX™ graphics cards
To install three CrossFire™ graphics cards:
1. Prepare three CrossFireX-ready graphics cards.
2. Insert the three graphics card into the PCIEX16 slots. If your motherboard has more
than three PCIEX16 slots, refer to Chapter 1 in this user manual for the locations of the
PCIEX16 slots recommended for multi-graphics card installation.
3. Ensure that the cards are properly
seated on the slots.
4. Align and firmly insert the two
CrossFireX™ bridge connectors to
the goldfingers on each graphics card.
Ensure that the connectors are firmly
in place.
5. Connect three independent auxiliary
power sources from the power
supply to the three graphics cards
separately.
6. Connect a VGA or a DVI cable to the
graphics card.