User Manual
Table Of Contents
- 安全上のご注意
- Chapter 1 製品の概要
- Chapter 2 基本的な取り付け
- Chapter 3 BIOS設定
- 3.1 BIOSの管理と更新
- 3.2 BIOS Setup Utility
- 3.3 Main
- 3.4 Advanced
- 3.4.1 CPU Configuration
- 3.4.2 Power & Performance
- 3.4.3 Server ME Configuration
- 3.4.4 Trusted Computing
- 3.4.5 ACPI Settings
- 3.4.6 APM Configuration
- 3.4.7 Runtime Error Logging Settings
- 3.4.8 Onboard LAN Configuration
- 3.4.9 Serial Port Console Redirection
- 3.4.10 Intel TXT Information
- 3.4.11 PCI Subsystem Settings
- 3.4.12 USB Configuration
- 3.4.13 Network Stack Configuration
- 3.4.14 CSM Configuration
- 3.4.15 NVMe Configuration
- 3.4.16 WHEA Configuration
- 3.4.17 Tls Auth Configuration
- 3.4.18 iSCSI Configuration
- 3.5 Chipset
- 3.6 Security
- 3.7 Boot
- 3.8 Monitor
- 3.9 Tool
- 3.10 Event Logs
- 3.11 Server Mgmt
- 3.12 Save & Exit
- Chapter 4 RAID
- 付録
ASUS WS C246M PRO/SE
5-5
付
録
Notices
Federal Communications Commission Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
• This device may not cause harmful interference.
• This device must accept any interference received including interference that may cause
undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with manufacturer’s instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment to an outlet on a circuit different from that to which the receiver
is connected.
• Consult the dealer or an experienced radio/TV technician for help.
The use of shielded cables for connection of the monitor to the graphics card is required
toassurecompliancewithFCCregulations.Changesormodicationstothisunitnot
expressly approved by the party responsible for compliance could void the user’s authority
to operate this equipment.