User Guide

3-60
Chapter 3: BIOS Setup
Chapter 3
Network Stack Driver Support [Disabled]
[Disabled] Select to skip the network stack driver from loading during POST.
[Enabled] Select to load the network stack driver during POST.
Redirection Support [Disabled]
This item allows you to enable or disable redirection support.
Conguration options: [Enabled] [Disabled]
Next Boot after AC Power Loss [Normal Boot]
[Normal Boot] Returns to normal boot on the next boot after an AC power loss.
[Fast Boot] Accelerates the boot speed on the next boot after an AC power loss.
Boot Logo Display [Auto]
[Auto] Auto adjustments for Windows requirements.
[Full Screen] Maximize the boot logo size.
[Disabled] Hide the logo during POST.
The following items appears only when you set the Boot Logo Display item to [Disabled].
Post Report [5 sec]
This item This item allows you to select a desired waiting time of the POST report from
0 to 10 seconds or until <ESC> is pressed.
The following items appears only when you set the Boot Logo Display item to [Full Screen]
or [Auto].
Post Delay Time [3 sec]
This item This item allows you to select a desired additional POST waiting time to
easily enter the BIOS Setup. You can only execute the POST delay time during normal
boot. The values range from 0 to 10 seconds.
DirectKey (DRCT) [Enabled]
[Disabled] The system will only turn on or off when the reset button is pressed.
[Enabled] Allow the system to turn on and go to the BIOS Setup directly when the
reset button is pressed. Connect the 2-pin connector of the chassis reset
button cable to the onboard DRCT header to support this function.
Boot up NumLock State [Enabled]
[Enabled] Set the power-on state of the NumLock to [On].
[Disabled] Set the power-on state of the NumLock to [Off].
Wait For ‘F1’ If Error [Enabled]
Enable this item for the system to pause until the F1 key is pressed when any error occurs.
Conguration options: [Disabled] [Enabled]
Option ROM Messages [Force BIOS]
This item allows you to set the display mode for Option ROM.
Conguration options: [Force BIOS] [Keep Current]