User's Manual
Table Of Contents
- 1 Introduction
- NOTE:
- NOTE:
- 2 Product Architecture
- 3 Electrical Specifications
- 4 Mechanical Specifications
- 5 Performance
- 1. BT in SW RF-KILL in all the tests
- 2. HB values refer to internal FE SKU
- 3. OS: Win10
- 1. Wi-Fi in SW RF-KILL in all the tests
- 2. OS: Win10
- 3. WsP is Master device
- 1. The TX power per MCS relate to IEEE, mask compliance and limited by regulatory TX power limits.
- 2. The values relate to internal FE SKU
- 3. The values are for typical device and typical conditions
- 1. Measured at ANT port
- 2. Typical means Nominal corner, AVG over non BE CHs. AVG over freq segment and chains
- 3. Max means over PVT
- NOTE: The throughput values relate to Intel® Skylake Platform and CPU, Single User.
- 6 Thermal Specifications
- 7 Regulatory
- 8 Dynamic Regulatory Solution
- 9 Platform Design Guidelines
- 9.1 Socket 1 key options for 2230 cards
- 9.1.1 Socket 1 Hybrid Key E scheme
- 9.1.2 Connectorized Hybrid Key E (2230) pin-out
- 9.1.3 Special considerations for the Hybrid Key E scheme
- 9.1.4 Soldered-down (1216) pin-out
- 9.1.5 Breakout example for JfP soldered-down module
- 9.1.6 Signal connection pitfalls
- 9.1.7 Pullups and pulldowns
- 9.1.8 IO connection scenarios and best practices
- 9.1.9 I/F specific guidelines
- 9.1.10 Connectivity module power control
- 9.1.11 Power supply de-coupling
- 9.1.12 Wi-Fi wireless disable and HW RF-KILL
- 9.1.13 M.2 Bluetooth HW RF-KILL
- 9.1.14 BIOS
- 9.1 Socket 1 key options for 2230 cards
Platform Design Guidelines
Intel
®
Wireless-AC 9560 (Jefferson Peak)
External Product Specification (EPS) April 2017
52 Intel Confidential Document Number: 567240–1.0
either a standard M.2 1216 card or an RF companion 1216 card. However, unlike in the connectorized
case, swapping cards requires removing a soldered-down module, and so can’t be done with a simple
socket card exchange. Additionally, the assembly tooling and BOM should change between a discrete
and CNVi motherboard assembly.
The special pad-out required for supporting CNVi and discrete is shown in Figure 9–3 and Figure 9–4.
(TBD: Add a diagram/table for connection diagram to show which pins can be shortened to
enable easier layout).
Figure 9–3 SD-1216 module pad-out for supporting CNVi and Discrete 1216 modules