ASUS NFC-PN544 MODULE User Manual
I. Introduction: ASUS NFC-PN544 is a module equipped with both NFC and USB3.0 Hub functions. It can be connected to Windows based systems by USB3.0 A to A type cable. The USB3.0 Hub is activated by embedded driver of Intel chipset(PCH) and the NFC is activated by NXP provided driver(only available on Win8) II. Design Reference: ASUS NFC-PN544 is composed as the following: a) USB3.0 hub IC: This section includes Asmedia ASM1074 chip and its external components completed refer to the reference design.
IV. Spec sheet: Antenna: On board PCB trace (size 32mm*54mm), basically a loop coil, formed by PCB trace Operating frequency: 13.
V.
FEDERAL COMMUNICATIONS COMMISSION INTERFERENCE STATEMENT This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Canada, avis d'Industry Canada (IC) Cet appareil numérique de classe B est conforme aux normes canadiennes ICES-003 et RSS-210.
