Quick Start Guide

ManualsBrandsASUSTeK Computer ManualsComputers & AccessoriesAX6600 Tri Band WiFi Router

ZenWiFi

AX6600 Tri Band WiFi Router

Model: XT8

Quick

Start Guide

Plug the adapter into the DCIN port, and press the power button.

The power LED will light up when your hardware is ready.

Hardware Explanations

Button and Port Explanations

Power buttonDC-IN port

WAN port

LAN ports 1-3 USB 3.0/2.0 port

WAN port

Connect your optical modem to this

port with a network cable.

LAN ports 1-3

Connect your PC to a LAN port with

a network cable.

Before Setup

ASUS Router App

AiMesh Setup Steps

Troubleshooting

Find two ZenWiFi XT8, and power both on.

Use a network cable to connect your optical modem to the WAN port of either ZenWiFi XT8.

This ZenWiFi XT8 will be the AiMesh router, and the other ZenWiFi XT8 will be the AiMesh

node.

The LED turns solid blue to indicate that ZenWiFi XT8 is ready for setup.

Preparing to set up an AiMesh Wi-Fi system

AiMesh Setup Steps

AiMesh routerAiMesh node

Download free ASUS Router APP to set up

and manage your router(s).

AiMesh routerAiMesh node

within

1-3 meters

Prepare

Place your AiMesh router and node within 1-3 meters of each

other during the setup process.

AiMesh node

Load factory defaults. Keep your router powered on and stand-

by for AiMesh system settings.

Enable Bluetooth on your phone. Launch ASUS Router APP, and then follow the on-screen in-

structions to ﬁnish the AiMesh setup.

Enabling Bluetooth Launching ASUS Router APP

03 04

If your AiMesh router cannot ﬁnd any AiMesh node nearby or

synchronization fails, please check the following and try again.

Move your AiMesh node closer to the AiMesh router ideally. Ensure that it is

within 1-3 meters.

Your AiMesh node is powered on.

DC Power adapter DC Output: +19V with max 1.75A current

Operating Temperature 0~40

C Storage 0~70

Operating Humidity 50~90% Storage 20~90%

Specications:

Summary of content (2 pages)

PAGE 1
Hardware Explanations 1 Plug the adapter into the DCIN port, and press the power button. 2 Quick Start Guide The power LED will light up when your hardware is ready. Button and Port Explanations DC-IN port Power button LAN ports 1-3 USB 3.0/2.0 port WAN port WAN port Connect your optical modem to this port with a network cable. LAN ports 1-3 ZenWiFi Connect your PC to a LAN port with a network cable.
PAGE 2
Relocation THE BEST PERFORMANCE Locate the AiMesh router and node at the best place. ZenWiFi XT8 LED indications Solid white: Good signal Solid yellow: Weak signal Solid red: No signal NOTES: To minimize interference, keep the routers away from devices like cordless phones, Bluetooth devices and microwave ovens. We recommend that you place the routers in an open or spacious location. FAQ FREQUENTLY ASKED QUESTIONS Q: Does the AiMesh router support Access Point mode? A: Yes.