User Manual

ManualsBrandsASUSTeK Computer ManualsElectronicsHP Touch Smart PC

Federal Communication Commission Interference Statement

This equipment has been tested and found to comply with the limits for a Class B digital

device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference in a residential installation. This equipment

generates, uses and can radiate radio frequency energy and, if not installed and used in

accordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If

this equipment does cause harmful interference to radio or television reception, which can be

determined by turning the equipment off and on, the user is encouraged to try to correct the

interference by one of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit different from that

to which the receiver is connected.

- Consult the dealer or an experienced radio/TV technician for help.

FCC Caution: Any changes or modifications not expressly approved by the party responsible

for compliance could void the user's authority to operate this equipment.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two

conditions: (1) This device may not cause harmful interference, and (2) this device must

accept any interference received, including interference that may cause undesired operation.

IMPORTANT NOTE:

FCC Radiation Exposure Statement:

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled

environment. End users must follow the specific operating instructions for satisfying RF

exposure compliance.

This transmitter must not be co-located or operating in conjunction with any other antenna or

transmitter.

FCC Radiation Exposure Statement:

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled

environment. This equipment should be installed and operated with a minimum distance of

20cm between the radiator and your body. This transmitter must not be co-located or

operated in conjunction with any other antenna or transmitter.

Operations in the 5.15-5.25GHz band are restricted to indoor usage only.

IEEE 802.11b or 802.11g operation of this product in the U.S.A. is firmware-limited to

channels 1 through 11.

Summary of content (21 pages)

PAGE 1
Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
PAGE 2
HP TouchSmart PC User Guide Copyright Information The only warranties for Hewlett-Packard products and services are set forth in the express statements accompanying such products and services. Nothing herein should be construed as constituting an additional warranty. HP shall not be liable for technical or editorial errors or omissions contained herein. HP assumes no responsibility for the use or reliability of its software on equipment that is not furnished by HP.
PAGE 3
Accessing Software and Performing Other PC Tasks You can access your software and perform various tasks on your HP TouchSmart PC using the touch screen, keyboard, mouse, stylus, or remote control. Some tasks are better suited to the touch screen, such as using the HP SmartCenter programs, browsing the Internet, or accessing your favorite programs. Some activities, such as typing search text, are better suited for the keyboard.
PAGE 4
Table of Contents Setting Up the HP TouchSmart PC .................................................................................1 HP TouchSmart PC Cables.........................................................................................................7 Setting Up the HP TouchSmart PC....................................................................................................7 Using surge protection ............................................................................................
PAGE 5
Using the HP TouchSmart PC Software...........................................................................................24 What is HP SmartCenter?........................................................................................................24 Navigating in HP SmartCenter .................................................................................................26 Opening HP SmartCenter .....................................................................................................
PAGE 6
Setting Up the HP TouchSmart PC This section provides figures you can use to locate the HP TouchSmart PC hardware, and information about setting up the HP TouchSmart PC and making connections.
PAGE 7
SmartCenter Activity LED Indicators DVD drive On/Standby Previous Track Play/Pause Next Track Audio/Video Connectors Built-in wireless LAN — use it to connect to a wireless home network that connects all the PCs in your home or office. See “Setting up a wireless local area network.” Bluetooth — connect to all kinds of wireless devices such as printers, cameras, headsets, cell phones, audio headphones, and more.
PAGE 8
Audio/video connectors — connect audio or video devices using these connectors. Also has manual keyboard and mouse connect button and indicator. L R S- Video 1394 USB 2.0 USB 2.0 Keyboard/Mouse Connect light L R S- Video 1394 USB 2.0 USB 2.0 Keyboard/Mouse Connect button Channel, volume, and mute controls — quickly change channels while watching live TV in Media Center and adjust the sound level for all your PC experiences.
PAGE 9
TV signal input connectors — input connectors on the left side of the HP TouchSmart PC are for the TV input signal. All models have a coaxial TV In connector. Some models also have an HDTV/ATSC connector. Some models also have S-video or video (composite) connectors and left Audio In and right Audio In connectors in this area. Some models have a coaxial FM antenna connector in this area. For more information about setting up your TV signal, see “Connecting the TV Signal Source to the PC” on page 13.
PAGE 10
Rear connectors — Connectors for AC power cord (with a green indicator light), a Kensington lock slot, LAN (for a wired Ethernet connection), four USB 2.0, HP printer Y-cable connectors (USB and power output), FireWire® (IEEE 1394) (6-pin), digital audio out (SPDIF), subwoofer/center, left and right surround, and left and right front are each 3.5 mm dual-channel analog audio out connectors, IR (infrared emitter) out, and a mini-VGA out connector.
PAGE 11
Photo printer exit — the print exits out of the front of the HP TouchSmart PC at the photo printer exit. + - HP Pocket Media Drive Bay — press the top of the drive bay cover to open it. Insert a portable HP Pocket Media Drive, which is a hard disk drive that you purchase separately. You can use it to store and transfer all of your important media files. + - You can safely remove the drive when the activity light on the drive is not blinking. Press the Eject button to pop out and then remove the drive.
PAGE 12
HP TouchSmart PC Cables For more information about cables, refer to the printed cable flyer that came with your HP TouchSmart PC. Power cable to connect the PC to the power source. Ethernet (RJ-45) cable (sold separately) to optionally connect the PC to a wired LAN (Ethernet) port. VGA adapter cable connects from the VGA Out connector to a standard 15-pin VGA connector on a TV or a monitor.
PAGE 13
Setting up the wireless keyboard and mouse CAUTION: You must follow the steps in the order listed to enable your keyboard and mouse to work with your HP TouchSmart PC. To set up the wireless keyboard and mouse: 1 Engage the batteries by pulling out the battery tabs from the bottom of the mouse and the keyboard. Battery pull tab Connect button 2 For the mouse only, move the switch on the bottom of the mouse to the On position.
PAGE 14
Using the Wireless Keyboard or Mouse You can use the keyboard within approximately 9.8 feet (3 meters) and the mouse within approximately 9.8 feet (3 meters) of the HP TouchSmart PC. Using the wireless keyboard This section describes some information about the wireless keyboard. For more information about keyboards, refer to “Using the Keyboard” in the Getting Started guide. Your keyboard is either a US version or a UK version. Keyboards US Keyboard is shown.
PAGE 15
Special Keyboard Buttons Button or key Description On/Standby turns the HP TouchSmart PC on or puts the HP TouchSmart PC into standby or sleep mode. Volume Up and Volume Down adjust the speaker sound level. Mute turns the sound off or on. The Function (Fn) key acts as a shift-down key for the Function keys; press Fn with a Function key (F1 through F12) to select the lower feature of the key. The Back key (press Fn+F1) moves back one window or Web page.
PAGE 16
Using the wireless mouse The cursor on the screen moves when you move the mouse. The wireless mouse operates with a Class 1 laser beam, which you cannot see. The mouse indicator light on the bottom of the mouse blinks when you turn it upside down to show that the batteries and the laser are working, and that the laser is off to protect you. Do not store the mouse upside down. To use the mouse, move the switch on the bottom of the mouse to the On position. Use the mouse on most surfaces.
PAGE 17
Manually sync the wireless keyboard or mouse Use these steps to manually sync the keyboard or mouse with the HP TouchSmart PC when either unit does not work properly after replacing the batteries. 1 For the mouse only, move the switch on the bottom of the mouse to the On position. 2 Place the keyboard or mouse on the same surface and within close proximity (12 inches or 30.5 centimeters) as the HP TouchSmart PC.
PAGE 18
Connecting the TV Signal Source to the PC NOTE: The number and type of cables required to connect your HP TouchSmart PC may vary by model. You may need to purchase extra cables separately. Your HP TouchSmart PC may not include all the cables you need for your computer setup, and the cables included may vary by model. Use these steps to connect the TV signal source, the FM signal antenna, or video and audio from a set-top box or DVD player. Some HP TouchSmart PC models have only the TV connector.
PAGE 19
FM antenna, TV In, HDTV/ATSC, S-Video, left and right audio connectors If your TV tuner looks like this, use the following procedure: 1 Connect the coaxial cable from your TV antenna or TV cable provider to the Cable/Ant connector on the left side of the HP TouchSmart PC. Or Plug a cable into the S-Video or video (composite) connector on the left side of the HP TouchSmart PC; use an S-Video cable or composite video cable.
PAGE 20
Connecting an HP Photo Printer Some HP photo printer models (A510 Series and A610 Series sold separately) can be placed on the printer dock on the back of the HP TouchSmart PC to provide a photo kiosk experience at home and save counter space at the same time. You can power the HP printer without using a separate power cable by connecting the printer to your HP TouchSmart PC using the included HP printer Y-cable.
PAGE 21
Setting Up the Remote Control Setting up the remote control to use with Windows Media Center Remove the back cover of the remote control and insert two AA batteries in the remote control. Make sure the batteries are inserted in the correct direction with the + and – symbols on the batteries matching the ones on the remote control. Using the remote control Point the remote control at the remote control sensor at the front of the HP TouchSmart PC, and press a button.