User's Manual

User Guide
ASUS
Tablet
E11431
First Edition / June 2016
Charging your ASUS Tablet
To charge your Tablet:
Connect the USB Type-C cable to the AC power adapter.
Plug the AC power adapter to a grounded power outlet.
Connect the USB Type-C cable to your ASUS Tablet.
Charge your ASUS Tablet for eight (8) hours before
using it in battery mode for the rst time.
Removing the MicroSD card tray
To remove the tray, insert the pin into the hole beside the tray.
NOTE: The memory card slot supports microSD and microSDXC
card formats.
Charging your device
Ensure to fully charge your ASUS Tablet before using it in battery
mode for extended periods. Remember that the power adapter
charges your ASUS Tablet as long as it is plugged into an AC
power source. Be aware that it takes much longer to charge the
ASUS Tablet when it is in use.
IMPORTANT! Do not leave the ASUS Tablet connected to the
power supply once it is fully charged. ASUS Tablet is not designed
to be left connected to the power supply for extended periods of
time.
Airplane precautions
Contact your airline provider to learn about related in-ight
services that can be used and restrictions that must be followed
when using your ASUS Tablet in-ight.
IMPORTANT! You can send your ASUS Tablet through x-ray
machines (used on items placed on conveyor belts), but do not
expose them to magnetic detectors and wands.
Safety precautions
This ASUS Tablet should only be used in environments with
ambient temperatures between 0°C to 35°C (32°F to 95°F).
Long time exposure to extremely high or low temperature
may quickly deplete and shorten the battery life. To ensure the
battery’s optimal performance, ensure that it is exposed within
the recommended environment temperature.
Your ASUS Tablet
Speaker/Headset port
Front camera
Ambient light sensor
MicroSD card tray
Touch screen panel
Audio speakers
USB Type-C port
Microphone
Rear camera
Volume button
Power button
Installing a microSD card
IMPORTANT!
• UseonlythebundledpoweradapterandUSBType-Ccableto
charge your ASUS Tablet. Using a dierent power adapter may
damage your ASUS Tablet.
• PeeltheprotectivelmofromthepoweradapterandUSB
Type-C cable before charging the ASUS Tablet to prevent risk or
injury.
• Ensurethatyouplugthepoweradaptertothecorrectpower
outlet with the correct input rating. The output voltage of this
adapter is DC 5V, 2A.
• WhenusingyourASUSTabletwhileplugged-intoapower
outlet, the grounded power outlet must be near the unit and
easily accessible.
• DonotuseorexposeyourASUSTabletnearliquids,rain,or
moisture.
• DonotuseyourASUSTabletnearheatingequipmentorin
places where there is likelihood of high temperature.
• KeepyourASUSTabletawayfromsharpobjects.
• DonotplaceobjectsontopofyourASUSTablet.
NOTE:
• YourASUSTabletcanbechargedviatheUSBportonthe
computer only when it is in sleep mode (screen o) or turned
o.
• ChargingthroughtheUSBportofacomputermaytakelonger
time to complete.
• Ifyourcomputerdoesnotprovideenoughpowerforcharging
your ASUS Tablet, charge your ASUS Tablet via the grounded
power outlet instead.
Appendices
Federal Communications Commission Statement
This device complies with FCC Rules Part 15. Operation is subject to the following two conditions:
• Thisdevicemaynotcauseharmfulinterference.
• Thisdevicemustacceptanyinterferencereceived,includinginterferencethatmaycauseundesired
operation.
This equipment has been tested and found to comply with the limits for a class B digital device, pursuant
to Part 15 of the Federal Communications Commission (FCC) rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee
thatinterferencewillnotoccurinaparticularinstallation.Ifthisequipmentcausesharmfulinterference
to radio or television reception, which can be determined by turning the equipment o and on, the user
is encouraged to try to correct the interference by doing one or more of the following measures:
• Reorientorrelocatethereceivingantenna.
• Increasetheseparationbetweentheequipmentandreceiver.
• Connecttheequipmentintoanoutletonacircuitdierentfromthattowhichthereceiveris
connected.
• Consultthedealeroranexperiencedradio/TVtechnicianforhelp.
Changes or modications not expressly approved by the party responsible for compliance could void the
user‘s authority to operate the equipment.
The antenna(s) used for this transmitter must not be co-located or operating in conjunction with any
other antenna or transmitter.
ForFCCandICe-labellinginformation,pleasegotoSettings > About > Regulatory information.
RF Exposure Information (SAR)
This device meets the government’s requirements for exposure to radio waves. This device is designed
and manufactured not to exceed the emission limits for exposure to radio frequency (RF) energy set by
the Federal Communications Commission of the U.S. Government.
The exposure standard employs a unit of measurement known as the Specic Absorption Rate, or SAR.
TheSARlimitsetbytheFCCis1.6W/kg.TestsforSARareconductedusingstandardoperatingpositions
accepted by the FCC with the EUT transmitting at the specied power level in dierent channels.
ThehighestSARvalueforthedeviceasreportedtotheFCCis1.01W/kgwhenplacednexttothebody.
The FCC has granted an Equipment Authorization for this device with all reported SAR levels evaluated as
in compliance with the FCC RF exposure guidelines. SAR information on this device is on le with the FCC
and can be found at www.fcc.gov/general/fcc-id-search-pageaftersearchingonFCCID:MSQP027.
15060-78400000
ZenTalk Fans Forum
www.asus.com/zentalk/global_forward.php
www.asus.com/support/