User Guide E12086 15060-xxxxxxxx
Revised Edition V3 / September 2016 Model: ASUS_X008D/ASUS_X008DA/ASUS_X008DB/ ASUS_X008DC Before you start, ensure that you have read all the safety information and operating instructions in this User Guide to prevent injury or damage to your device. NOTE: For the latest updates and more detailed information, please visit www.asus.com.
Side features Audio jack Nano SIM / micro SIM card slot Eject hole Volume key Power key Microphone Micro USB port
Rear features Flash Rear camera Fingerprint sensor NOTES: • • The Nano SIM / micro SIM card slots support GSM, WCDMA, FDD-LTE, and TDD-LTE network bands. The microSD card slot supports microSD and microSDXC card formats.
Charging your ASUS Phone To charge your ASUS Phone: 1. Connect the USB connector into the power adapter’s USB port. 2. Connect the other end of the USB cable to your ASUS Phone. Plug the power adapter into a wall socket. 3. 3 2 1 IMPORTANT! • When using your ASUS Phone while it is plugged to a power outlet, the grounded power outlet must be near to the unit and easily accessible. • When charging your ASUS Phone through your computer, ensure that you plug the USB cable to your computer’s USB port.
Installing a Nano SIM/ micro SIM / microSD card To install a Nano SIM/ micro SIM/ microSD card: 1. Push the bundled eject pin into the hole on the card slot to eject the tray out. 2. Insert the Nano SIM, micro SIM, or microSD card into the appropriate slot.
3. Push the tray to close it. IMPORTANT! Both SIM card slots support 4G / 3G / 2G network band. But only one SIM card can connect to 4G service at a time. CAUTION! • • • Do not use sharp tools or solvent on your device to avoid scratches on it. Use only a standard Micro SIM or Nano SIM card on your ASUS Phone. For more regulatory information and E-labels, check on your device from Settings >About > Regulatory Information.
Federal Communications Commission Statement This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user‘s authority to operate the equipment.
The country code selection is for non-US models only and is not available to all US models. Per FCC regulation, all WiFi products that are marketed in US must be fixed to US-operated channels only. RF Exposure Information (SAR) This device has been tested and meets applicable limits for Radio Frequency (RF) exposure. Specific Absorption Rate (SAR) refers to the rate at which the body absorbs RF energy. SAR limits are 1.
Canada, Industry Canada (IC) Notices This device complies with Industry Canada’s licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) This device may not cause interference; and (2) This device must accept any interference, including interference that may cause undesired operation of the device. Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence.
exposure limits. The Wireless Device should be used in such a manner such that the potential for human contact during normal operation is minimized. This device has been evaluated for and shown compliant with the IC Specific Absorption Rate (“SAR”) limits when installed in specific host products operated in portable exposure conditions. Canada’s REL (Radio Equipment List) can be found at the following web address: http://www.ic.gc.ca/ app/sitt/reltel/srch/nwRdSrch.
Avertissement Le guide d’utilisation des dispositifs pour réseaux locaux doit inclure des instructions précises sur les restrictions susmentionnées, notamment: CAN ICES-3(B)/NMB-3(B) This Class B digital apparatus complies with Canadian ICES-003. Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada. This device and its antenna(s) must not be colocated or operated in conjunction with any other antenna or transmitter, except tested built-in radios.
CE RF Exposure Compliance This device meets the EU requirements (1999/519/ EC) on the limitation of exposure of the general public to electromagnetic fields by way of health protection. For body-worn operation, this device has been tested and meets the ICNIRP guidelines and the European Standard EN 62209-2, for use with dedicated accessories. SAR is measured with this device at a separation of 0.
CE marking for devices with wireless LAN/ Bluetooth This equipment complies with the requirements of Directive 1999/5/EC of the European Parliament and Commission from 9 March, 1999 governing Radio and Telecommunications Equipment and mutual recognition of conformity.The highest CE SAR values for the device are as follows: • • 0.590 W/Kg (Head) 0.
Prevention of Hearing Loss To prevent possible hearing damage, do not listen at high volume levels for long periods. Safety information ASUS Phone care • Use your ASUS Phone in an environment with ambient temperatures between 0 °C (32 °F) and 35 °C (95 °F). The battery Your ASUS Phone is equipped with a high performance non-detachable Li-polymer battery. Observe the maintenance guidelines for a longer battery life.
• • • • • • • Do not remove and soak the battery in water or any other liquid. Never try to open the battery as it contains substances that might be harmful if swallowed or allowed to come into contact with unprotected skin. Do not remove and short-circuit the battery, as it may overheat and cause a fire. Keep it away from jewelry or metal objects. Do not remove and dispose of the battery in fire. It could explode and release harmful substances into the environment.
optimally in an ambient temperature between 0 °C (32°F) and 35 °C (95 °F). • • Do not disassemble the ASUS Phone or its accessories. If service or repair is required, return the unit to an authorized service center. If the unit is disassembled, a risk of electric shock or fire may result. Do not short-circuit the battery terminals with metal items.
Proper disposal Risk of explosion if battery is replaced by an incorrect type. Dispose of used batteries according to the instructions. DO NOT throw the battery in municipal waste. The symbol of the crossed out wheeled bin indicates that the battery should not be placed in municipal waste. DO NOT throw this product in municipal waste. This product has been designed to enable proper reuse of parts and recycling.
EU Declaration of Conformity W e, th e un d er sign ed , Manuf a ctur e r: ASU ST eK C OMP UTE R I NC. Addr e ss: 4F, N o. 15 0, LI-TE R d., PEITO U, TAI PEI 11 2, TAIW AN Autho rized rep r es ent ativ e in Eu rop e: ASU S CO MP UTE R G mb H Addre ss, City: HA RKO RT ST R.
UE Declaración de Conformidad No sotr os, lo s ab ajo f ir m ant es, Fabri can te: ASU ST eK CO MP UTE R IN C. Dir ec ción: 4F, N o. 15 0, LI-TE R d., PEITO U, TAI PEI 11 2, TAIW AN Rep r es ent ant e auto riz ado en Eu ropa : ASU S CO MP UTE R G mb H Dir ec ción, Ciud ad: HA RKO RT ST R.
Declaração CE de Conformida de Nó s, o s ab aixo- assin ad o s, Fabri can te: ASU ST eK C OMP UTE R I NC. Ende re ço: 4F, N o. 15 0, LI-TE R d., PEITO U, TAI PEI 11 2, TAIW AN Rep r es ent ant e auto riz ado na Europ a: ASU S CO MP UTE R G mb H Ende re ço, cid ade: HA RKO RT ST R.
EU Uygunluk Beyanı Biz , b u imz a altın d akiler Ür eti ci: ASU ST eK C OMP UTE R I NC. Adr e s: 4F, N o. 15 0, LI-TE R d., PEITO U, TAI PEI 11 2, TAIW AN Avrup a’daki Y etkili: ASU S CO MP UTE R G mb H Adr e s, Şehi r: HA RKO RT ST R.
ASUS Address: 4F, No.150 Li-Te Rd., Peitou, Taipei, Taiwan Tel: 886228943447 Fax: 886228907698 Declaration We declare that the IMEI codes for this product, ASUS Phone, are unique to each unit and only assigned to this model. The IMEI of each unit is factory set and cannot be altered by the user and that it complies with the relevant IMEI integrity related requirements expressed in the GSM standards. Should you have any questions or comments regarding this matter, please contact us.
