Installation Manual

AS1004T / AS1004T v2

Connecting and Powering on the NAS

1. Connect the NAS to its power supply.

2. Connect the NAS to your router, switch or hub using an Ethernet cable.

3. Press and hold down the power button located on the back of the device for 1 – 2 seconds until the yellow

power LED indicator is lit. This indicates that the NAS is now powered on. While the NAS is being powered

on, the yellow system status LED indicator will flash and the yellow network LED indicator will be lit as well.

4. The NAS is ready for operation once the yellow system status LED indicator has stopped flashing and

remains steadily lit. At this time, you should also hear a ‘beep’ from the system buzzer. Hardware installation

is now complete. Please move on to the software installation guide to configure your system settings.

Note: If the device has been subjected to strong shaking or shock, it is recommended that you remove

the cover to ensure that the hard disks are properly installed and that the screws are properly fastened.

AS1002T / AS1002T V2

AS1004T / AS1004T V2