Specifications

Maintenance 3-7
Adjustment of the Rail Parallelism
If a printed circuit board (PCB) falls down into the oven, the conveyor rail needs adjustment.
To adjust the conveyor rail parallelism:
1. Turn the power off by moving the Main Switch to the OFF position. Wait for the temperature
to decrease to cool.
WARNING! Before performing this procedure, it is critical that you wait for the temperature to
decrease to cool. Failure to do so could result in serious injury.
2. Lift the hood to access the conveyor rails.
CAUTION!
3. With a slide caliper, measure the input width of the conveyor (
When opening the hood to make adjustments, refer to “Hood Opening/Closing
Operation” in the TC V3 Operations Manual.
Figure 3-5).
Figure 3-5 Conveyor Input
4. With the same slide caliper, measure the output width of the conveyor (Figure 3-6).
Figure 3-6 Conveyor Output
B
A