Specifications

3-8 Maintenance
5. If the input and output measurements are not equal, remove the access cover located under
the crank to access the transmission gear. Unscrew the two locking screws (Figure 3-7).
Insert one of the screws in the third hole to free the gear’s hub and tighten. Make necessary
adjustments and replace the locking screws.
6. Replace the access cover.
Figure 3-7 Conveyor Transmission Gear
7. Next, measure the width of the rail at the input (C) (Figure 3-8), at the middle section (D)
(Figure 3-9), and at the output (E) (Figure 3-10).
Figure 3-8 Input Rail
Figure 3-9 Mid-Section Rail
Locking
Screw
Hub
Gear
Insert screw here
to free hub
Locking
Screw
C
D