User's Manual

ManualsBrandsAT&T ManualsAutomotiveWireless Car Charger

Speciﬁcations

Input: 5VDC/2A; 9VDC/1.67A

Output: Up to 10W on select devices

Charging distance: 6mm

So pad to provide a stable surface

Includes:

Car Wireless Charging Doc,

Vent Mount and Suction Mount,

Holder, VPC and cable.

Compatible with all Qi-enabled devices.

F000xxxR00

This device complies with Part 18 of the FCC Rules.

Operation is subject to the following two conditions:

(1) this device may not cause harmful interference, and

(2) this device must accept any interference received,

including interference that may cause undesired operation.

CAUTION:

Changes or modiﬁcations not expressly approved by the

party responsible for compliance could void the user’s

authority to operate the product.

Note:

This equipment has been tested and found to comply with

the limits for a wireless power charger, pursuant to Part 18 of

the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference in a

residential installation. This equipment generates, uses and

can radiate radio frequency energy and, if not installed and

used in accordance with the instructions, may cause harmful

interference to radio communications. However, there is no

guarantee that interference will not occur in a particular

installation. If this equipment does cause harmful

interference to radio or television reception, which can be

determined by turning the equipment oﬀ and on, the user is

encouraged to try to correct the interference by one or

more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment

and receiver.

• Connect the equipment into an outlet on a circuit

diﬀerent from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technicia

for help.

This equipment complies with FCC radiation exposure

limits set forth for an uncontrolled environment. This

equipment could be installed and operated with

minimum distance 0cm between the radiator and your

body. This transmitter must not be co-located or operating

in conjunction with any other antenna or transmitter.

210 mm x 90 mm, double side printed (Outside)299C K100