User Manual
Table Of Contents
- Getting started
- Telephone operation
- Intercom operation
- One-touch setup and operation
- Using a 1080 mailbox
- Glossary
- Time/date
- Centrex operation
- General product care
- Important product information
- For C-UL compliance
- FCC and ACTA information
- Part 15 of FCC rules
- Limited warranty
- Technical specification
- Index
- Troubleshooting
4
Getting started
Display screen messages
Continued on next page
LCD CONTRAST
Your set's display provides important information.
You can adjust the screen contrast to one of eight
levels to optimize readability in dierent lighting
conditions.
1. Press [ENTER].
2. Press [ ] or [ ] until you see SPECIAL OPTIONS.
Press [ENTER].
3. Press [ ] or [ ] until you see LCD CONTRAST.
4. Press [ ] or [ ] to select the appropriate
screen contrast level (1-8).
5. To move to the next feature, press [ ].
-OR-
To exit setup, press and hold [ENTER].
SPECIAL OPTIONS
LEVEL-4
LCD CONTRAST
AC FAIL There is no AC power to the set. If a good battery
is installed, basic phone operation (such as
making and answering calls on the handset)
is supported. Speakerphone, headset and call
privacy are not supported. The handset volume
will be at the minimum level and only the
two lowest levels of the ringer volume will be
available.
DND The Do Not Disturb mode is on.
DTAD: XX/YY Flashes when the mailboxes of the DTAD
mailbox 1080 telephone are full or when the auto
attendant of the DTAD mailbox 1080 telephone
is o. (XX is the total number of new system
extension messages recorded for this 1040
telephone. YY is the total number of all system
extension messages recorded for this 1040
telephone.)
(EMPTY) The one-touch location is empty.
EXT XX RING There is an incoming Centrex call.