Installation Manual

31
One touch
Continued from previous page
• Store a signal for switching to temporary
tone dialing. If you have dial pulse (rotary)
service, this signal is required for some special
services. Press [ ] or [ ] until you see TONE,
then press [ENTER]. A T appears on the
screen. All numbers you enter aer this will
send touch-tone signals during dialing.
• You can store the ash signal required by
some special services as part of a dialing
sequence. Press [ ] or [ ] until you see
FLASH, then press [ENTER]. An F appears on
the screen. Continue storing the number as
usual.
• To erase the last digit, scroll to DELETE
CHAR and then press [ENTER].
-OR-
Press [REMOVE].
• To copy the most recently dialed number
from redial, press [(AUTO) REDIAL]. You
can copy only the last number dialed from
this extension to a one-touch location. You
cannot copy the other numbers in the redial
stack.
• To cancel programming, scroll to CANCEL
and then press [ENTER].
5. Press the desired one-touch key to store the
telephone number in a location.
-OR-
Press [LOWER], then the desired one-touch
key to store the telephone number in the lower
location.
6. To move to the next feature, press [ ].
-OR-
To exit, press and hold [ENTER].
PROGRAM
5550100
PAUSE
PROGRAM
5550100
TONE
PROGRAM
5550100
FLASH
PROGRAM
5550100
DELETE CHAR
PROGRAM
5550100
CANCEL