User Guide

Remote Operation
Remote Access Code
The Remote Access Code is preset to 10. You can use the preset code or choose one of your own.
Displaying Your Code
Hold down CODE. The Remote Access code appears in the Message Window.
Changing your code
The Remote Access code can be changed from the preset code to any number from 10 to 99.
1. Hold down CODE. The remote Access code appears in the Message Window.
2. While holding down CODE, press REPEAT to decrease the code or press FORWARD to increase it.
3. Release CODE when the desired code is displayed.
4. To see the new code, hold down CODE. The new code appears in the Message Window.
Note
: If AC powers and you have no battery installed (or the battery is low on power), the Remote Access
code returns to the factory setting of 10.
Using your Code
To enter your Remote Access code:
1. Dial your telephone number from a touch tone telephone.
2. Wait until the system answers, then use the buttons on the telephone to enter your Remote Access
code.
When then Remote Access code is entered correctly, the system announces the number of messages (“You
have X Messages”) and then beeps twice, indicating that it is ready for a remote command.
Note
: To bypass the announcement (or if the MESSAGES switch is set to NO), enter your Remote Access
code as soon as the announcement begins. If the announcement does not stop, enter your code again.
Playing Messages and Memos
When you call your answering system from another location, you must enter your Remote Access code.
You may then listen to your messages or enter a command to request one of the following features available
to you.
After you finish using one feature the system beeps twice to let you know you can enter another command.
Playing All Messages
When you dial your number and enter your Remote Access code, the system waits 4 seconds, then begins
playing all messages automatically.
To bypass the 4 second wait and begin playing your messages immediately, press and release 7 after the 2-
beep signal.
The system beeps once after each message and announces “ End of messages” after playing the last
message.