AT&T 135 Quark pdf 7/22/98 11:26 AM Page 1 Design Line Telephone 135 User’s Manual Part 2 © 1998 Philips Consumer Communications, L.P. All rights reserved. Printed in Mexico.
AT&T 135 Quark pdf 7/22/98 11:26 AM Page 2 PARTS CHECKLIST Remember to save your sales receipt in case you ever need warranty service, and make sure this telephone package includes the items shown below: Handset Telephone Coiled handset cord Base 7-foot line cord 5-inch line cord Ringer Volume Dial Mode Switch 1
AT&T 135 Quark pdf 7/22/98 11:26 AM Page 3 INSTALLATION Dial Mode Switch Selection Set the Dial Mode switch on the side of the set to TONE (touch tone) or PULSE (dial pulse/rotary) telephone service. Make sure you choose the correct dialing method; touch tone dialing will not work if you have dial pulse service. The temporary tone dialing is activated by pressing while in pulse mode. Table 1. Remove the base by sliding it sideways as indicated by the “REMOVE” arrow. 2.
AT&T 135 Quark pdf 7/22/98 11:26 AM Page 4 INSTALLATION (continued) 2. Connect short line cord to telephone. Plug the 5-inch line cord into the LINE jack on the bottom of the phone. 3. Reinstall the base. Turn the base so that the larger end is toward the bottom of the telephone. Reinstall the base by inserting the top tabs into the phone slots. Then slide sideways in the direction of the “INSTALL” arrow to lock into the phone. 4. Reverse the handset tab.
AT&T 135 Quark pdf 7/22/98 11:26 AM Page 5 OPERATION Redial The telephone always stores in memory the last number dialed. To dial the same number again, press . The redial memory can accept numbers up to 24 digits long. The number will remain in memory until you change it by dialing another telephone number. For privacy, you can erase the redial memory. Lift the handset, then press any digit (1-9).
AT&T 135 Quark pdf 7/22/98 11:26 AM Page 6 OPERATION (continued) Temporary Tone Dialing Temporary tone dialing is used only when you have rotary service. It allows you access to services that require tone signaling, including some toneactivated computer systems (e.g., telephone banking). To change from pulse (rotary) to tone dialing during a call: 1. Dial a telephone number with the dial mode switch set to PULSE. 2. Press ; all buttons pressed after this will send tone signals. 3.
AT&T 135 Quark pdf 7/22/98 11:26 AM Page 7 MEMORY (continued) Directory Card: Remove the directory card. Write your telephone number in the space provided. Also write the telephone numbers (or names) that you want to store in each memory location. Reinstall the card and clear plastic cover. NOTE: Numbers programmed into a memory location might not be retained if the telephone has been unplugged from the line jack for a half hour or more. Speed Dialing To program numbers into memory: 1. Press . 2.
AT&T 135 Quark pdf 7/22/98 11:26 AM Page 8 IN CASE OF DIFFICULTY If this telephone does not work properly, try the following suggestions before seeking repair assistance. No Dial Tone ☞ Make sure all plugs are connected properly. Inspect the line cord connections at the modular jack and at the telephone. Also inspect the coiled handset cord connections at both ends. ☞ Unplug the telephone and connect it to another modular jack.
