User Guide

The Remote Access code is preset to 10. This number is printed on the label under the access cover. You
can use the preset code or you can choose one of your own.
You can change this code by calling from a remote location. However, you cannot change this code at
home.
Note
: If Ac power fails and there is no battery installed, or the battery is low on power, the Remote Access
code returns to the factory setting of 10.
Changing your Remote Access Code
1. Dial your telephone number from a touch tone telephone.
2. When the system answers, enter your current Remote Access code. The system announces the number
of messages it has received, then beeps twice.
3. Press and release 9 9. The system beeps once.
4. Enter your new Remote Access code (any number between 10 and 99, except 30 or 50).
•
If valid code number is entered, the system changes the Remote Access code and beeps twice.
•
If an invalid number is entered, or no new number is entered, you hear 5 rapid beeps, followed by 2
beeps. Repeat steps 3 and 4.
Playing Messages
1. Dial your telephone number from a touch tone telephone.
2. When the system answers, enter your Remote Access code.
Note
: To bypass the announcement, enter your Remote Access code as soon as the announcment begins. If
the announcement does not stop, enter the code again.
When the Remote Access code is entered correctly, the system announces the number of messages it has
received then beeps twice. After the beeps, you can:
•
Wait 4 seconds and the system will automatically begin playing all of your messages.
•
Press and release 7 to begin playing all of your messages.
•
Press and release 6 to begin playing only new messages.
If there are no messages, you hear five rapid beeps.
The following options are available while you play your messages:
•
To repeat an entire message, press and release 2 while that message is playing.
•
To repeat part of a message, hold down 2. To resume playing the message, release2.
•
To skip and entire message, press and release5 while that message is playing.
•
To skip part of a message, hold down 5. To resume playing the message, release 5.
•
To interrupt message playback, press and release #. To resume playing messages, press and release 7.
•
To delete only a selected message, press and release 3 while that message is playing. To be sure you
are deleting the right message, you can press 2 to repeat the message and then press 3 when you are
sure that the system is playing the message you want to delete.
Saving Your Messages
To save messages you’ve just heard, simply hang up the telephone. Any new messages will be recorded
after the saved messages.