User Guide

Replaying Your Messages
After all messages have been played and you hear “End of messages” followed by 2 beeps, press and
release 7 to replay the messages.
Deleting All Messages
If you do not want to save any of your messages, press and release 3 3 after you listen to all your messages
and hear “End of messages”, the messages are deleted immediately and the system beeps twice.
Recording a Memo
After you listen to your messages, you can record a memo to yourself or other members of the household.
1. After you hear “End of Messages” followed by two beeps, press and release *.
2. Begin speaking after the beep.
3. Press and release # when you are finished.
This memo will be counted as a new message.
Changing Your Announcement
To change your announcement:
1. Dial your telephone number.
2. When the system answers, enter your Remote Access code during or after the announcement.
3. After you hear the 2 beeps, press and release 4 *. The system will beep and begin recording.
4. Speak into the telephone in a normal tone of voice.
5. When you are finished press and release #. The system automatically plays your new announcement.
To listen to your announcement again, press and release 4 1 after the 2 beeps.
Bypassing the Announcement
People who call frequently can press * (on touch tone phones only) when the announcement begins. The
system skips the rest of the announcement, beeps, and begins recording.
Turning Off the System
Use the following procedure to turn off the system:
1. Dial your telephone number.
2. When the system answers, enter your Remote Access code during or after the announcement.
3. After the 2-beep signal, press and release 8 8. The system beeps twice. You can hang up and the
system will not answer incoming calls until you turn it on again.
Turning On the System
If you forget to turn the system on before leaving home, you can turn it on by calling from a touch-tone
telephone. (You do not have to enter your Remote Access code to use the feature.)
1. Dial your telephone number and wait for 10 rings. The system will answer and beep twice. ( It will not
play your announcement.)
2. Press and release 0. The system beeps twice to indicate that the system has been turned on. You can
hang up and the system remains on, ready to answer calls and record messages.