User Guide

Note
: If you press 0 and hear 5 rapid beeps instead of the normal 2 beep signal, then either memory is full
or no announcement is recorded. See “Memory Full/ No Announcement.”
Memory Full / No Announcement
If the system answers after 10 rings and presents 2 beeps instead of your announcement, then the system
may be off, or memory may be full, or your announcement may have been lost due to a power failure with
insufficient battery power.
To set your system to answer calls and record messages:
1. Enter your Remote Access code after the 2-beep signal.
2. Listen to any messages that have been recorded and delete some or all of them.
3. Press and release 4 1 to review your announcement. If you don’t hear your announcement, press and
release 4* to record a new announcement. (See “Changing Your Announcement”.)
4. Press and release 0 to make sure your system is on before you hang up.