User Guide

Speed Dialing
: Once a number is stored in memory you can dial it by pressing MEMORY and then the
memory location key (1-9).
If your system is disconnected from AC power for approximately 15 minutes when there is no battery
power, memory dialing numbers will be lost. To restore them, repeat the steps in “ Storing Numbers.”
Note
: You may choose to store emergency numbers in memory locations. However speed dialing is
provided only as a convenience. AT&T assumes no responsibility for customer reliance on this memory
feature.
Although testing the programming of emergency numbers is not a recommended procedure, if you do make
a call to an emergency number:
•
You must remain on the line and briefly explain the reason for the call before hanging up.
•
Programming / testing of emergency numbers should be performed in the early morning or late evening
(off-peak hours).
Storing Numbers
1. Lift the handset or press SPEAKER.
2. Press and release PROGRAM.
3. Enter the telephone number to be stored.
4. Press and release MEMORY.
5. Press and release the memory location (1-9) where the number is to be stored. You cannot use 0, # or *
as memory locations.
6. Hang up, or press SPEAKER.
Repeat the above steps to store another number.
Dialing Stored Numbers
1. Lift the handset or press SPEAKER.
2. Press and release MEMORY.
3. Press and release the memory location (1-9).
Storing Numbers Just Dialed
Whenever you make a telephone call, the number you dialed can be stored in a memory location without
entering the number again.
1. Lift the handset or press SPEAKER.
2. Press and release PROGRAM.
3. Press and release MEMORY.
4. Press and release the memory location (1-9).
5. Hang up or press SPEAKER.
Answering System Operation
Recording Your Announcement