User Guide

Recording a Memo
You can record a memo to be stored by the system as an incoming message. You can then play the memo at
home or from a remote telephone, like any other message. The memo can be up to 2 minutes long.
1. To record a memo, press and release MEMO.
Speak toward the microphone. While you are recording, the Message Window shows “-“ (flashing).
2.To stop recording, press and release STOP.
The system stores the memo with your messages and updates the message count.
To listen to the memo, follow the instructions under “ Listening to Your Messages”
Priority Calling
If you do not want to be disturbed, your system will answer the phone for you. However, if there is a
particular call you would like to receive, inform the caller of Priority Calling.
When the caller enters the Priority Calling code from a touch tone telephone, the system beeps loudly to
alert you to a priority call.
The Priority calling code is set at 30 and cannot be changed.
To use Priority Calling, a caller should:
1. Dial your telephone number.
2. When the announcement begins to play, press and release 3 0.
3. The system beeps 3 times, then pauses. This pattern is repeated until the telephone is picked up. The
beeps are audible to the caller as well as in the home.
If the phone is not answered within 30 seconds, the caller hears 2 beeps. The caller can then press and
release *, and leave a message after the beep.
When Memory is Full
The system can record approximately 9 minutes of messages (including the time for your announcement) or
a maximum of 50 messages. When memory is full or 50 messages have been recorded, “F” flashes in the
Message Window. To make room for more messages, listen to your messages and delete some or all of
them.
When memory is full, the system will answer calls after 10 rings and present 2 beeps instead of your
announcement. See “ Memory Full No Announcement.”
REMOTE OPERATION
Your Remote Access Code
You can use many features of your system when you are away from home. To protect your privacy, most
features can be used only after you enter a Remote Access code.
Note
: To enter your Remote Access code and use other remote features, you must call from a touch tone
telephone.