Switch User's Manual

Issue 2 December 1995 8-15

Setting a Security Level

The factory sets the SID to access level 1. When you first power on the SID, the

unit accesses the SETUP menu and allows you to access all tools required to

perform the administration tasks. You can select a security level for the SID and

make the security level part of the configuration. AT&T recommends that you

select security level 0 as the normal operating mode for the SID. Users only can

access level 0 features, which reduces the risk of tampering by unauthorized

users.

Use the following instructions to set the security level on the SID.

1. Press to access the MAIN menu as shown in the following

example:

2. Press to select the UTILS menu as shown in the following example:

3. Press to select the LOGIN form as shown in the following example:

4. Press the arrow (<- ->) keys to change the access level to 0.

5. Press to save the change. The SID immediately updates your

security level.

To log in to level 1, use the instructions above to access the LOGIN form. Use the

arrow keys to set Access Level to 1. The SID now asks you for a password. Type

in the level 1 password and press .

NOTE:

As you type the password, you do not see the letters on the screen.

When you complete the instructions in this chapter, proceed to Chapter 9,

"Acceptance Tests", in this document.

NEC 1-View 2-Utils 3-System

4-Setup 5-Logs

UTILS 1-Login 2-Date/Time 3-Serial

<- ->0 Password

FUNC

ENTER