User manual

AT&T Plug&Share
™
Wireless PCI Adapter 108 Mbps 6550G 5
STEP 4: Configure the PCI adapter for your wireless network
Check the Utility icon (four vertical bars) next to your computer’s time display. If the bars are
green, you are already connected and do not need to run the Wizard (skip to page 7). If the bars
are not green within 30 seconds, double-click the Utility icon, then click the Run Wizard button
at the next screen.
Wizard screen 1
SSID: Enter the SSID (Service Set Identifier) used by your
wireless router or access point.The default SSID is at&t.The
SSID is case sensitive (i.e.,“cat” and “Cat” are not the same). All
wireless adapters on your network must use the same SSID as
your wireless router and/or access point.
WEP: WEP is a form of wireless encryption. If you click On
to enable WEP in your wireless adapter, you must turn on WEP
in your router, and make sure all devices use the same settings.
Click Apply to save your settings and display Wizard screen 2
(see next page).
CAUTION: SSID and all WEP settings must be identi-
cal in all wireless network devices. WEP
Ascii/Hex Key
must match the WEP settings used in your router (may
be called Security Phrase
, Hex Key or other term).
Enter up to 32
letters or numbers
Double-click to run Utility.
Number of green bars
shows signal strength.