Owner`s manual

Testing and Maintenance

Replacing Batteries in Keypads and Universal Transmitters

Batteries should be replaced whenever they are low. Test the Universal

Transmitter weekly to be sure it is working properly (see page 32 for the

procedure used to test the transmitter battery power and operation).

To Replace Batteries:

1 Put your system in the DEMONSTRATION mode. (Set the system to

Off, then press and hold Test/Demo

the Central Controller for 3

seconds.)

To remove the transmitter cover, press upward on the release tab at

the bottom of the transmitter. Remove the transmitter cover by lifting it

up and out at the bottom.

NOTE:

This will

set off an alarm, but since the system is in the

DEMONSTRATION mode, it is only a test alarm. It will sound at a

lower volume and will not activate your telephone dialer or any external

sirens. Cancel the test alarm if you wish.

3 Remove the battery and discard it.

Replace the battery with a 9-volt battery (Duracell MN1 604, or

Eveready 522). Attach the battery lead and set battery into the

transmitter body.

Re-attach transmitter cover to the backplate.

Test transmitter to be sure it operates properly (see page 32).

Take your system out of the DEMONSTRATION mode by pressing

Test/Demo on the Central Controller. The system will automatically

return to normal operation if no activity occurs within 10 minutes while

in the DEMONSTRATION mode.