Owner`s manual

Testing and Maintenance

Replacing

PIRT

Batteries

Batteries should be replaced whenever they are low. Test the PIRT weekly

to be sure it is working properly (see page 32 for procedures used to test

PIRT

battery power and operation).

To Replace Batteries:

Put your system in the DEMONSTRATION mode. (Set the system to Off,

then press and hold TestDemo in the Central Controller for 3 seconds.)

Use a coin to press down on the

PIRT

release tab (located in a slot at the

top of the backplate). Pull the top of the backplate away from the trans-

mitter body to release it.

NOTE:

This

will set off an alarm, but since the system is in the

DEMONSTRATION

mode, it is only a test alarm. It will sound at a lower

volume and will not activate your telephone dialer or any external sirens.

Cancel the test alarm if you wish.

Remove the

PIRT

housing by pulling it up and away from the bottom of

the baseplate.

Remove the batteries and discard them.

Replace the batteries with new 9-volt batteries (Duracell MN1 604, or

Eveready 522). Attach the battery leads and set the batteries into the

transmitter body.

Re-attach the

PIRT

housing to the backplate.

Test the

PIRT

to be sure it operates properly (see page 32).

Take your system out of the DEMONSTRATION mode by pressing

Test/Demo on the Central Controller. The system will automatically return

to normal operation if no activity occurs within 10 minutes while in the

DEMONSTRATION mode.