Owner`s manual

Here is a brief guide to the operation of your AT&T Security System 8000. For more
detailed instructions, see the Owner’s Manual pages noted. Please pay special attention
to the Safety Procedures (pages 2-4) which give important information not covered here.
When Leaving Home (see page 7)
1 Enter your security code on the keypad attached to the door. The transmitter will
beep 3 times in quick succession as the last number is entered correctly.
2 Press Away. The Central Controller will beep once.
3 Press Open. The transmitter will beep 3 times.
4Go out the door and close it. The system will arm itself in about 40 seconds
When Returning Home (see page 8)
1 Enter your home through a door that has been set for entry. The Central Controller
will begin beeping once every 3 seconds.
2 Enter your security code within 40 seconds. This will cancel the delayed alarm.
3 Press Home. This will disable all the interior sensors.
Sounding a Panic Alarm (see page 8)
Simultaneously press both sets of red dots on the keypad.
Turning Your System Off (see page 8)
11 Enter your security code on the keypad. The system will beep 3 times.
2 Press Off. All intrusion sensors will be turned off. Fire alarms remain armed.