User`s manual

Getting started

Wall mounting

To return the bracket from the tabletop position to wall mounting, follow the

directions below.

A single two-line wall jack

If there is a single two-line wall jack, use only the black line cord. Install the

telephone as shown below:

NOTE: This product is designed to operate optimally with two telephone lines.

If you choose to install only one telephone line, the telephone will continue to

operate normally as long as the unused line is not selected. If you experience diffi-

culty, make sure you have pressed the correct LINE key.

3. Wind the line cord around the

hooks and on the bracket.

Thread the line cord through

the hole . Insert the line cord

into the groove as shown.

4. Press the bracket downwards until

it firmly clicks into place. Plug the

other end of the black line cord

firmly into the wall jack. Place the

telephone mounting holes and

just above the mounting studs,

then slide the telephone base down

until it is held securely.

5. When mounting the telephone on a

wall, you must reverse the handset

tab to hold the handset in place. Hold

down the switchhook, and slide the

tab up and out of its slot. Turn the

tab so that the end with the lip is up.

Insert the tab back into its slot.

1. Press the tab

as shown and

flip the bracket

to wa rd s t h e

downward posi-

tion.

2. Plug one end of the

black line cord into

the jack labeled L1

or L1/L2 on the

back of the tele-

phone base. Insert

the line cord into

the groove.

Line 1 + Line 2