User`s manual

Getting started

Installation options

Your telephone base is ready for tabletop use. If you want to mount your

telephone on a wall, use the provided wall mount bracket to connect with

a standard dual-stud telephone wall mounting plate. If you do not have this

mounting plate, you can purchase one from many hardware or consumer

electronics retailers. You might need a professional to install the mounting plate.

Tabletop to wall mount installation

With the upper tabs (marked A) on top, align the holes of the wall mount

bracket with the studs on the standard wall mounting plate and slide the

bracket down until it locks securely.

Plug one end of the telephone line cord into the jack on the bottom of the

telephone base and plug the other end into the telephone wall jack (or

DSL filter). Plug the small end of the telephone base power adapter into

the jack on the bottom of the telephone base and plug the other end into

an electrical outlet not controlled by a wall switch. Route the telephone

line cord and the power cord through the grooves at the bottom of the

telephone base accordingly.

Hold the cords to the side of the telephone base. Align the upper slots on

the back of the telephone base just above the upper tabs of the wall mount

bracket. Make sure the lower slots of the telephone base are also aligned

above the lower tabs of the wall mount bracket. Push the telephone base

down and against the wall mount bracket until it clicks securely in place.

If necessary, bundle the telephone line cord and power adapter cord

neatly with twist ties.

1 2

Raise the

antenna