User`s manual

Getting started
3
Telephone base and charger installation
Install the telephone base and charger as shown below.
IMPORTANT INFORMATION
Use only the power adapter(s) supplied with this product. To order a replacement
power adapter, visit our website at www.telephones.att.com or call
1 [phone]. In Canada, dial 1 [phone].
For more detailed instructions, refer to the online Complete user’s manual at
www.telephones.att.com/manuals.
The power adapters are intended to be correctly oriented in a vertical or floor
mount position. The prongs are not designed to hold the plug in place if it is
plugged into a ceiling, under-the-table or cabinet outlet.
1.
2.
Charger installation
Telephone base installation
Plug the large end of the
charger power adapter into an
electrical outlet not controlled
by a wall switch.
Telephone line cord
A DSL filter (not included)
is required if you have
DSL high-speed Internet
service. The DSL filter
must be plugged into the
telephone wall jack.
Plug the small end of
the telephone base
power adapter into the
power jack on the back
of the telephone base.
Plug the large end of
the telephone base
power adapter into an
electrical outlet not
controlled by a wall
switch.
Plug the other end
of the telephone line
cord into the TEL. LINE
jack on the back of the
telephone base.
Plug one end of the
telephone line cord
into a telephone jack
or a DSL filter.
Route the cords
through the channels.
Telephone base
Charger