Instruction manual
CHAPTER 4. ADMINISTRATIVE TASKS-SYSTEM
Note: Remote Access users should be careful when using any command that requires user
1.
2.
3.
4.
input such as
next page.
This command, if not used properly, will not let the system
time out after 30 minutes and logoff the user. If the command is not used properly,
system alarms cannot be reported which may affect system service.
If not translated previously, translate four Netcon channels. (See “How to Administer
Netcon Channels” in this chapter.)
Translate a Uniform Call Distribution (UCD) Hunt Group using a Hunt Group form.
a. In the
Group Extension
field, enter an extension number. If the system is
equipped with Direct Inward Dialing (DID), enter a DID extension number.
b. In the
Group Members Assignment
field, enter the four extension numbers
(non-DID numbers) previously assigned to the four Netcon channels.
If the system will be remotely administered from an on-premises terminal, no additional
translations are required.
If the system will be remotely administered from an off-premises location via a dial-up
facility, complete Steps 3 and 4.
Translate a pooled modem if not translated previously.
Translate a trunk group in one of the following ways described
in the table below.
DID Equipped Systems
DID Equipped Systems
Using a Non-DID Trunk
Non-DID Equipped Systems
(calls made from Remote
[off-premises] terminal will be to the
Listed Directory Number [LDN])
Non-DID Equipped Systems
(calls made from Remote
[off-premises] terminal will be to a
trunk dedicated to Remote Administration)
Using a DID Trunk Group form, translate
a new trunk. The NAME (TeI. number)
assigned in the
Group Member
Assignments
field
must
be the same
DID number assigned to the UCD hunt
group (see step 2a).
Using a CO Trunk Group form, translate
a new trunk group. In both the
Incom-
ing Destination and Night Ser-
Vice
fields, enter the UCD hunt group
extension number (see Step 2a).
If not translated previously, translate a
Trunk Group containing the LDN.
Using a CO Trunk Group form, translate
a new trunk group. In both the
Incom-
ing Destination and Night Ser-
vice
fields, enter the UCD group exten-
sion number (see Step 2a).
4-5