User`s manual

Speakerphone
Use the following procedures if your voice terminal is set for the
Speakerphone (listen and speak) feature.
NOTE: If your voice terminal is set for the Speakerphone feature, you
can adjust the speakerphone to the surrounding room acoustics to
provide optimal performance. Use the directions in "Setting the
Speakerphone" in the section titled Features Accessed with the
Display and Softkeys.
To place/answer a call without lifting the handset or to use the
speakerphone with any voice feature
1 Press
Speaker .
The red light next to
Speaker goes on.
2 Place or answer the call or access a selected feature.
3 If you are placing a call, dial the telephone number.
4 Adjust the speakerphone volume if necessary.
To raise the volume, press the right half of the Volume control
button labeled
;
to lower the volume, press the left half of the Volume control
button labeled
.
5 Press
Speaker to hang up.
The red light next to
Speaker goes off.
To prevent the other party from hearing you
NOTE: If the Speakerphone feature is not active, the Mute feature turns
off the microphone associated with the handset (not the speakerphone).
1 Press
Mute .
The red light goes on and the other party cannot hear you.
2 Press
Mute again to resume talking to other party.
The red light goes off and the other party can hear you again.
To change from speakerphone to handset
1 Lift handset and talk.
The red light next to
Speaker goes off.
16