User`s guide
FAX Attendant Initial Implementation
Administering Switch Interface Parameters
Some specific parameters are necessary to tell FAX Attendant how to communicate
with System 25. For convenience, these parameters are collected on FORM B and
are explained below.
✏ NOTE:
The switch interface parameters are automatically set to correct values for the
System 25. This information is for troubleshooting purposes only. Do not
change the switch interface parameters unless they have been accidently
changed from the values shown. (Different values are used with other
communications systems.)
Switch Interface Administration
Switchhook Flash Duration 600
Wink Disconnect Interval 300
Signaling Type TT
Incoming Speech Volume 4000
Outgoing Speech Volume 1000
Dial Tone Training Yes
The contents of each field should be:
■
Switchhook Flash Duration specifies the on-hook duration in milliseconds
that the switch recognizes as a transfer request. The range is 300 to 1550
milliseconds. The correct (and default) is 600 milliseconds.
■
Wink Disconnect Interval specifies the on-hook duration in milliseconds that
the switch recognizes as a disconnect request. The range is 300 to 800
milliseconds. The correct (and default) is 300 milliseconds.
■
Signaling Type specifies whether Touch-Tone (TT) or dial-pulse (DP)
signaling is used. The correct (and default) is TT.
NOTE:
Incoming Speech Volume, Outgoing Speech Volume,
and
Dial-Tone
Training
are not administrable.
✏
2-10