User's Manual

Page 7
Operational Instructions
Charge your H100 through any USB jack or wall charger.
The LED indicator will glow red when charging. Before
using for the rst time, charge at least 4 hours. Aer the
rst charge, the headset will charge in 2 to 3 hours and the
LED indicator will turn o when the charge is complete.
Note: When the battery is fully charged, the LED indicator will change to blue.
Charging
Press and hold the ON/OFF button for 2-3 seconds to
switch the headset on. The LED will ash blue when
powered on. Press and hold the ON/OFF button for 3
seconds to switch the headset o. When powering o, the
LED will ash blue and then turn o indicating the headset
is o.
Power ON/OFF
While the headset is o, press and hold the ON/OFF – for
2-3 seconds to start pairing mode. Once the headset is in
the pairing mode (the LED will ash red and blue), select
‘H100’ among discovered Bluetooth devices on the phone
to Pair.
Note: If the headset is not paired with a Bluetooth device in 3 minutes, it will turn
itself o.
Pairing