User`s guide

Test (Local Test)
The Local Test allows you to verify the operation of the visual and audio warning
signals.
Note: For procedures for the Wireless Test (which tests signal strength and voice
quality and determines terminal identification), see ‘‘Test (Wireless Test)’’ directly
after this feature.
To verify the operation of
the telephone’s visual and
audio warning signals
1 Remove the handset from the base
2 Hold down
# (on the dial pad) for five seconds.
While still holding down
# , press
On/Off .
The BATT, P, ON, MSG, MUTE, and RANGE
icons light, and you hear a double beep emitted
from the handset
3 To exit the local test mode, press the handset
On/Off
button
Note: If the ringers do not sound or the indicators do
not appear, contact your system manager.
Test (Wireless Test)
The Wireless Test allows you to determine signal strength and voice quality and
identify the location of your handset’s radio module in the radio base station
(terminal identification).
To test for signal
strength and voice
quality and to determine
terminal identification
1 Turn the handset off
2 Hold down
9 (on the dial pad) for at least five
seconds. While still holding down
9 , press
On/Off .
The T (for Test) icon is lit, and you hear a double
beep
3 At this point, you can make the following tests:
Test for sound clarity in the following manner:
When you enter Wireless Test Mode, you hear
dial tone through the handset earpiece. Listen to
the dial tone as you walk around. Clear, steady
dial tone indicates good sound clarity.
14