Instruction manual

MERLIN LEGEND Communications System Release 5.0
Installation
555-650-140
Issue 1
June 1997
Installing the PC, CAT, or Printer
Page 5-16
Connecting a Printer to the Control Unit
Figure 5-5. Connecting a Printer Within 50 ft. (15.2 m)
To connect a printer within 50 ft. (15.2 m), follow the steps below. Refer to
Figure 5-5
.
Plug the short end of a Z200A EMI cord into the SMDR jack on the
control unit.
Plug the other end of the Z200A EMI cord into a 355AF or 355A
adapter.
Plug the female end of the adapter into either the 25-pin male
connector on the printer’s interface cable or the serial port on the
printer.
Set the appropriate printer options for SMDR.
See ‘‘
Setting Printer Options and DIP Switches’’ for instructions.
CAUTION
POWER
ON



OFF
AG INPUT
FR
GND
Turn off
power before
inserting or
removing
modules
408 GS/LS
44GS or LS Outside Lines/
8 Analog Telephones (ATL)
408
008 MLX
8 MLX (Digital) Telephones
012
355AF
Adapter
Z200A
EMI
Filter
EIA-232-D
SMDR Printer
SMDR
Jack
Control Unit
Processor Module