Instruction manual

Initializing and Testing the System
Page 7-1
Initializing the System
MERLIN LEGEND Communications System Release 5.0
Installation
Issue 1
June 1997
MERLIN LEGEND Communications System Release 5.0
Installation
555-650-140
Issue 1
June 1997
7
7
Initializing and Testing the System
When you have finished installation, you are ready to initialize the system as
described in this chapter.
Initializing the System
To initialize a Release 5.0 system, use one of the following methods:
■ Restore from a 5.0 system programming disk or Translation memory
card.
■ Upgrade to Release 5.0 from Release 1.0, 1.1, 2.0, 2.1, 3.0, 3.1, 4.0, 4.1,
4.2, or 5.0. See Chapter 9, ‘‘
Upgrading the System’’.
■ Use system programming forms and the procedures from one of the
guides listed in the next section, “Programming Guides.”
This section describes how to restore the system from the Translation memory
card or the system programming disk.
NOTE:
On initial installations, make sure you perform a System Erase (frigid
start), as described in
Maintenance and Troubleshooting, either
immediately before you restore from a disk or memory card or before you
program the system. Failure to perform the System Erase (frigid start) can
result in incorrect programming.