Instruction manual

MERLIN LEGEND Communications System Release 5.0
Installation
555-650-140
Issue 1
June 1997
Initializing and Testing the System
Page 7-9
Testing the System
Testing Tie Trunks
Before you test tie trunks, make sure that the tie trunks for the system are
connected and properly programmed. Have someone at the far end ready to
place and receive calls throughout the testing procedures listed below.
The tie trunk testing procedures in this section are as follows:
■ Automatic-start two-way (both incoming and outgoing)
■ Automatic-start incoming only
■ Automatic-start outgoing only
■ Dial-repeating two-way (both incoming and outgoing)
■ Dial-repeating incoming only
■ Dial-repeating outgoing only
NOTE:
Dial-repeating tie trunks are also called wink-, immediate-, and delay-type
tie trunks.
These terms are used in system programming to describe the
type of signaling used on the trunk.
Testing Two-Way Automatic-Start Tie Trunks
For two-way automatic-start tie trunks, perform both the incoming and outgoing
automatic-start tie trunk tests.
Before testing outgoing or two-way automatic-start tie trunks, have someone
ready to take your call at the receiving telephone.
Testing Incoming Automatic-Start Tie Trunks
Perform this test for automatic-start tie trunks that are two-way or incoming only.
If you are testing two-way automatic-start tie trunks, perform the outgoing test
as well.