Instruction manual

MERLIN LEGEND Communications System Release 5.0
Installation
555-650-140
Issue 1
June 1997
Upgrading the System
Page 9-17
Modifying the Processor for Key Mode
Figure 9-6. Removing the Processor Module Circuit Board
Holding the processor circuit board at each end, lift it up and turn it
over and away from you. See Figure 9-6
.
Place the processor circuit board on a flat, non-metallic surface.
Carefully support the dip switch assembly with your index finger,
while moving the switch to the closed position. See Figure 9-7
.
Replace the processor circuit board face (components) down into
the module housing.
Replace the processor module side panel and clip into place.
Replace the processor module into the carrier. See Figure 9-4.
Power up the system.
Processor
PROCESSOR MODULE
Lift Circuit board
Up and Over