Instruction manual

MERLIN LEGEND Communications System Release 5.0
Maintenance and Troubleshooting
555-650-140
Issue 1
June 1997
Control Unit Problems
Page 4-121
CTI Link Problems
The following screen appears if the port is not a CTI Link.
Exiting from the non-CTI Link screen returns you to the selection screen shown
in Step 2 for you to enter a new port number and try again. The following screen
appears if the port is a CTI Link.
Console Display/Instructions Additional Information PC
Select Status.
Select Exit.
Station:
xxxx is dial plan
Make a selection
number, slot/port, or
Status
logical ID.
Busy Out
Restore
Exit Enter
CTI Link xxxx :
xxxx is dial plan number,
Make a selection
slot/port, or logical ID.
Status Test
Restart
Exit
CTI Link xxxx :
xxxx is dial plan number,
SlotPort: xxxx
slot/port, or logical ID.
Physical Link:
Physical Link: up or down
PBX Driver Conn:
PBX Driver Conn: up or down
Alarms:
Alarms: suspended or active
Maintenance Busy:
Maintenance Busy: yes or no
Exit
A yes in the Maintenance Busy
field means that the slot shown
in the Slot/Port field of this screen
is maintenance busy. Do a slot
restore on that slot.