Instruction manual

MERLIN LEGEND Communications System Release 5.0
Maintenance and Troubleshooting
555-650-140
Issue 1
June 1997
Introduction
Page 1-12
Using SPM
Pick up the handset on the T/R telephone and dial the remote
access trunk number.
This is possible only if a trunk is programmed as a dedicated trunk for
remote access to the built-in modem.
If the dial tone begins with three short tones followed by a steady
tone, dial the remote access barrier code from the T/R telephone;
otherwise, go to Step 5.
If you do not know the remote access barrier code, contact the
customer’s system manager, or check Form 3a, Incoming Trunks:
Remote Access. If the system accepts the barrier code, you hear ringing
followed by dial tone.
NOTE:
You can change the barrier code without knowing the old one only when
you perform on-site maintenance through the ADMIN jack.
Connect to the modem on the remote system.
When you hear dial tone, dial
*10 .
When you hear the modem tone, hang up.
If nothing appears on the SPM screen, press
.