Instruction manual

MERLIN LEGEND Communications System Release 5.0
Maintenance and Troubleshooting
555-650-140
Issue 1
June 1997
Error Logs, Access Logs, and System Inventory
Page 2-7
Error Logs
Table 2-2 Continued
Continued on next page
Error
Codes Description Action
0009 FRIGID START:
System was restarted and initialized
to default programming.
This error is also logged after a
System Erase.
If the processor was removed while in
use, the system may perform a frigid
start due to loss of system programming.
Restore system as described in
System
Programming and Maintenance
(SPM) ,
or in Appendix D, ‘‘
Backing Up with a
Memory Card’’.
000A POWER UP COLD START:
A RAM failure was detected in the
processor.
System programming is okay.
If problem persists, troubleshoot the
processor.
000B CARD INSERTED/REMOVED: No action required.
000C SLOT STREAM CNT EXCEEDED:
Slot has generated excessive
interrupts.
If problem persists, troubleshoot the
module.
000D FMWR NOT IN STANDBY MODE:
Module firmware is not in standby
mode.
If problem persists, troubleshoot the
module.
000E COMMAND BUFFER FULL: If problem persists, troubleshoot the
processor and module.
000F TASK RUNNING TOO LONG: No action required: however, if problem
persists, troubleshoot the processor.
0010 INVALID SLOT INTERRUPT:
Cannot determine module
responsible for generating the
interrupt.
Troubleshoot modules and replace if
necessary. If problem persists,
troubleshoot the processor.
0011 STACK OVERFLOW:
Processor problem.
Troubleshoot the processor.