Instruction manual

Installing Telephones and Adjuncts
4. Drill two diagonally opposite holes for each piece of hardware. You
can drill right through the template. See Figure 3-30.
There is a 1/16-inch (1.6-mm) space between the outline of each piece
of hardware; keep this space as you mount the hardware.
Figure 3-30. Drilling Holes for Each Piece of Hardware
5. Remove the template from the wall. Keep it in one piece so that you
can check it for correct placement of hardware.
6. Mount the wire troughs and termination blocks on columns 1 and 3 as
needed.
3-58 Connecting the Telephones to the Control Unit