Instruction manual

Connecting the Control Unit to the Network Interface

Figure 4-4. Using the D-Impact Tool to Seat the Conductors

10.

Label the network interface jacks, control unit module jacks, termination

blocks, and D2R cords (see “Labeling Trunks” later in this chapter).

For each trunk, plug one end of a D2R cord into the designated jack on

the termination block and the other end into the trunk jack on the

proper control unit module.

NOTE:

The modular jacks on the termination block are 8-wire jacks. The

D2R cords, which are 6-wire, will plug into the 8-wire jacks as well.

4-10 Wiring