Instruction manual

Installing the Carriers
2-25
Installing the Control Unit
To install the basic carrier, follow the steps below:
1. Install the horizontal mounting bracket on the backboard using at least two
#10 X 3/4” long wood screws supplied.
Make sure that the bracket is level.
2. Install the top of the vertical mounting bracket into the slot on the horizontal
mounting bracket to form a “T,” as shown in Figure 2-5. Secure the vertical
mounting bracket with at least one #10 X 3/4” long wood screw in the
bottom hole.
Figure 2-5. Mounting the T brackets
3. Install the left and right mounting brackets on the rear of the carrier with the
four #10 - 24 X 1/2” long machine screws supplied, as shown in Figure 2-6.