Installation guide

Programming Steps
First access the PagePac Plus system and enter the programming mode
by pressing [
* ] [ * ] and entering your Programming password (if optioned).
You may exit the programming mode by dialing [
# ].
You will need to repeat this procedure for each output zone or zone group
that you wish to receive the DTMF tones.
1.
Dial [ 9 ] [ 0 ] to select this option.
Hear a DOUBLE beep.
2.
Enter the zone number, of the zone or group you wish to configure to
receive the DTMF. Use ALlAS numbers, if optioned. Otherwise, use
Physical zone/group numbers.
Hear a DOUBLE beep.
3.
Enter [
0 ] or NO (Not pass DTMF) or enter [ 1 ] for YES (Pass DTMF)
Hear TRIPLE beeps.
To verify the status of DTMF Pass for a given zone, dial [
9 ] [ 1 ] and repeat
steps 2 and 3 above.
These actions are summarized in table 2-21.
Table 2-21. Pass DTMF to the Output
Feature
Mode Option/
Verify
Dial
Listen
For
Zone/Group
Selection
Listen
For
Choose Option
Listen
For
Default
Pass
DTMF to
the
Output
To Select
To Verify
90
91
Double
Beep
(Z,G)
Double
Beep
0 – No
1 – Yes
Triple
Beeps
No
2-30 Programming The Controller